Hi Guys, I have recently fitted my model 2 saturn with an access led and now I'm interested in fitting region switches. There is plently of info out there on how to do it, but could someone just explain some of the terminology for me? Ok I have established that there are three sets of jumpers I should be looking at. They are, 6,7 10,11 and 12,13. I have located these on the Saturn mainboard. Now when I look at these jumpers in detail, there is two solder points on each jumper. Am I right in assuming that one solder spot is a power supply (3.3v or 5v I think), and the other solder spot is an earth/ground point. Now, the next step is to cut the link between jumpers, does this mean to cut the link between the two solder spots on each jumper, or to cut the link JOINING each jumper? Ok with that done, the next task is to find the common points between jumpers, what exactly does this mean? Is it to find the earth/ground point side of each jumper? And then finally I solder wires to the jumpers I want regions for and simply fit a switch. Ok so that would be according to gamesx.com's schematic, connect jumper 10 and 7 for U.S., 10 and 12 for EUR, and 11 and 6 for JAP? Could someone please advise before I start cutting my Saturn apart. Cheers guys